THIS IS
PARTS PAGE 4
Engine sprocket and Clutch Hub puller tool.
Only  $3.75
Counter
Factory 2 Stroke HIGH PERFORMANCE
Original LDZ Spark Plug. Only $1.99
Gasket Patch. 1/16" super thick fuel proof.
Perfect for making those Intake Manifold or
Carburetor gaskets.  Only $1.00 . Patch size
is 4x6 cm approximately.
Gear Box "POWER TAKE OFF" BOLTS UP TO THE
CLUTCH PACK SIDE OF THE TITAN MOTOR AND
OTHER MOTORS.  ALLOWS FOR POWER TAKEOFF.  
5:1 REDUCTION . 78mm ID Bell. ONLY $22.49 .
PTO 10T 1/2 inch DRIVE SPROCKET STEEL . Fits
Gear Box PTO and other gear boxes with 6 cog
spline. New Style one Piece milled. ONLY $11.99
PTO SPROCKET RETAINER CLIP SNAP
RING. KEEPS SPROCKET ON TO THE
SPLINE SHAFT OF THE PTO UNIT.
ONLY $1.99
Carburetor Float White Plastic Donut. Fits most
Carbs 50cc to F80 Type Engine Carbs. This is the
Carburetor Float that regulates fuel flow into the
Carburetor.
Only $4.49
Rope Start Pull Rope Starter. Fits Titan XC50,
Honda GX50, Huaseng, and others.
Only
$29.00
NT Air Cleaner Screws. Pair. For mounting your
NT style Plastic Air box to carburetor.
You get 2 screws, 2 flat, and 2 lock washers.
Only $1.99
Carb needle and C Clip. Only $3.99
TITAN Jack Shaft Drive Sprocket 1/2in Fits
R1-R3 Titan Jack Shafts. New Style Milled one
piece. Only  $9.99
A pair of Clam Shell Adapters. These allow engine
mounting to large frame tubes without drilling.
Only $4.99
TORCH RTC 4 Stroke High Performance Spark
Plug. Fits Titan, Super Titan, 14X Series motors,
Honda GX and more. Get the performance from
your Engine lost by using other spark plugs. If
your engine is in need of more power, get this
TORCH RTC High Performance Plug Now While
Supplies Last ! Only $3.99
GOTO PARTS PAGE 5
GOTO PARTS PAGE 3
GOTO PARTS PAGE 2
GOTO PARTS PAGE 1
GOTO HOME PAGE
GOTO PARTS PAGE 1
GOTO PARTS PAGE 2
GOTO PARTS PAGE 3
THIS IS
PARTS PAGE 4
GOTO PARTS PAGE 5
GOTO HOME PAGE
Clutch pad.
Fits Titan, HS
and other
motors. Only
$3.99 ea.
OUT OF STOCK
2 Stroke Copper Core HIGH PERFORMANCE
Spark Plug. Only $4.99
Here we have an Awesome Gear Box from DAX. This is the DAX 3.25 Gear Box.
It is Dual Chain Driven. This gear box is not only smooth, but built to last. All
bearings are roller and since it has dual Chains and sprockets, will provide a
long life with minimal stretching. Mount is Standard 4 hole and Bell is also the
Standard 76-78 mm type. Reduction is 3.25:1. Spline is also standard 6 spline
PTO.
Only 39.99 and comes with a 1 year Warranty.
11T T8F 8mm Drive Sprocket 6 Cog Spline. Uses 8mm
drive Chain.
Only $9.99.