TITAN INSTALLATION PAGE 1
There are two rear sprocket rag
joint binders. Cut one of them and
only one. Cut only  between the
drilled holes.
STEP 1
STEP 2
Place the cut rag joint sprocket
binder that you have just cut on
the inside of the hub as shown.
STEP 3
Place the other rag joint sprocket binder on
the outside of the hub. Here is a Big TIP:  
Take the rear sprocket and hit the ends of
each tooth both sides with a grinding wheel
to knock the chrome off of the tip and to
taper it a little. This aids in the breaking in
process for the chain and the rear sprocket.
If you do not do this, then, you may have a
chain that will want to ride high or get caught
on the edge of the sprocket teeth and then
come off the sprocket.
STEP 4
Thread the nine bolts and use the half moon
backing plates, tighten all nine bolts moving
across in a star fashion and a little at a time to
allow for an even pull down. Once sprocket is tight
using the flat washers and lock washers and
locking nuts  provided, Spin wheel and check
sprocket for True.  Deviation can be no more than
1.5mm both orbital and x Axis or side to side.
Typically any side to side excess deviation can be
corrected by using a sharpie and spinning wheel
and then tightening the sprocket where needed in
order to get correct alignment.  Make sure bolts
are tight.
Counter
TITAN INSTALL PAGE 2
HOME
TITAN INSTALL PAGE 2
HOME