REAR SPROCKET INSTALL
COMPLETED
COMPLETED
This is how the sprocket should
look when installed. Good Job !!!
look when installed. Good Job !!!
TITAN INSTALLATION PAGE 2
STEP 5
Install to the rear stays of your bicycle
both Engine Carrier Support Brackets.
Install these as low down as possible and
make sure the two are level with each
other.
both Engine Carrier Support Brackets.
Install these as low down as possible and
make sure the two are level with each
other.
OUTWARD BIAS
INWARD BIAS
RIGHT BIAS
LEFT BIAS
Next Step is to decide what fits your bike
best. These are the Offset T Brackets. The
pictures are showing you the 4 different
ways in which they can be used to best
match the rear end Engine Carrier Support
Brackets you mounted in Step 5. Place
both Offset T Brackets onto your engine
carrier and then hold over the Engine
carrier Brackets to see what bias fits
best. Once you have decided for the best
fit, then go ahead and mount the T
brackets to your Carrier plate and make
the nuts finger tight for now.
best. These are the Offset T Brackets. The
pictures are showing you the 4 different
ways in which they can be used to best
match the rear end Engine Carrier Support
Brackets you mounted in Step 5. Place
both Offset T Brackets onto your engine
carrier and then hold over the Engine
carrier Brackets to see what bias fits
best. Once you have decided for the best
fit, then go ahead and mount the T
brackets to your Carrier plate and make
the nuts finger tight for now.
Here I have placed my T Brackets on to my
Plate above and not seen, and down below
where the T bracket meets the Engine
Carrier Support Brackets, you can see
this is a pretty good match. SEE ARROWS.
You can see in the next picture that I have
the left Bias and this was a good match
for this bike.. So. I will use this for my bike.
Left Bias for me. Your Bias may be
different. Depends on the bike.
Plate above and not seen, and down below
where the T bracket meets the Engine
Carrier Support Brackets, you can see
this is a pretty good match. SEE ARROWS.
You can see in the next picture that I have
the left Bias and this was a good match
for this bike.. So. I will use this for my bike.
Left Bias for me. Your Bias may be
different. Depends on the bike.
<==
==>