CLUTCH PACK REMOVAL STEP 1.
USE AN IMPACT  TO REMOVE 6MM
BOLT FROM CENTER OF CLUTCH
PACK
DO NOT USE THE 6MM BOLT YOU
JUST REMOVED FOR THIS STEP. GET
ANOTHER 6MM BOLT THAT IS
LONGER AND SCREW IT DOWN AS
FAR AS YOU CAN. GENTLY PRY FROM
BEHIND AND TAP BOLT WITH HAMMER
UNTIL CLUTCH PACK COMES FREE.
USING NEEDLE NOSE PLIERS,
UNLOAD ALL 3 SPRINGS .
UNSCREW THE THREE BUSHING
BOLTS WITH SPRING WASHERS
AND PUT A SMALL AMOUNT OF
GREASE ON THE BUSHING BOLT
AND SCREW THEM BACK IN.
TITAN CLUTCH PACK REMOVAL
AND MAINTENANCE
NOTE: IF YOU ONLY WANT TO
GREASE THE BUSHINGS, CLUTCH
PACK REMOVAL IS NOT NEEDED TO
DO THIS. YOU CAN UNLOAD THE 3
SPRINGS AND THEN REMOVE THE
BUSHING BOLTS AND GREASE
WITHOUT REMOVING THE CLUTCH
PACK.
HOME
BACK
TITAN INSTALL PAGE 1